Sunday, February 3, 2019

Avital 4000 Remote Programming Instructions

This Avital 4000 system uses replacement remote: 473T, 7133L, 473V, 473L, EZSDEI474
473T  Remote
473V Remote
473L Remote
7133L Remote

The following Learn Routine can be used to program this replacement transmitter to the system in order to enter the Learn Routine, The system's Valet/Program switch must be plugged into the BLUE port.

1. Door. Open a door.
2. Key. Turn the key to the ON position.

3. Press and release the Valet/Program button within 5 seconds  the number of times corresponding to the channel listed below. Once you have selected the channel, press and hold the valet button this time. The LED should flash the same number of times as the channel selected and the siren (if was installed properly) will chirp to confirm the selected channel. DO NOT release the valet button yet.
4. Press the button from the remote you're assigning to that channel. If the horn siren was works, then you should get a chirp which means the remote has been programmed.
5. Release the Valet/Program button and remove the key from the ignition.


This chart is for 473V, 473P, and 473T Remote
This chart is for 473L Remote

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below