Tuesday, February 19, 2019

Dealer Installed Toyota Securikey Remote Programming Instructions

This Dealer Installed Toyota Securikey system uses replacement remote: ELVAT6B, PROTX6
Elvat6b, Protx6 Replacement Remote
Elvat6b, Protx6 Remote

1.  Start with valet switch OFF
2.  Turn key to ON
3.  Press the valet switch ON then OFF 3 times.
4.  Press the LOCK button on every remote you wish to program for 3 seconds, one after another.  Horn will sound after each.
5.  Press valet switch ON then OFF.  Hear 2 beeps.
6.  Press the UNLOCK button on every remote you wish to program for 3 seconds, one after another.  Horn will sound after each.
7.   Press valet switch ON then OFF.  Hear 3 beeps.
8.  If the Trunk Release Upgrade Kit is not present then skip to next step.  Hold TRUNK button for 3 seconds on every remote you wish to program, one after another.  Horn will sound after each.
9.  Press valet switch ON then OFF.  Hear 4 beeps.
10.  If there are no Securikey+ Upgrade Kit present then skip to next step.  Hold TRUNK button for 3 seconds on every remote you wish to program, one after another.  Horn will sound after each.
11.  Press valet switch ON then OFF.  Hear 5 beeps.
12.  Do not program any remote buttons to channel 5.  Skip to next step.
13.  Press valet switch ON then OFF.  Hear 6 beeps.
14.  If there is no Securikey+ Remote Start Kit present then skip to next step.  Hold REMOTE START button for 3 seconds on every remote you wish to program, one after another.  Horn will sound after each.
15.  Turn key to OFF.  Hear a soft and loud beep.  Programming is complete.

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below