Tuesday, February 26, 2019

Hornet 742 Remote Programming Instructions

This Hornet 742 system uses replacement remote: 473T, 7133L, 473V, 473L, EZSDEI474
473T  Remote
473V Remote
473L Remote
7133L Remote
The following Learn Routine can be used to program this replacement transmitter to the system in order to enter the Learn Routine, The system's Valet/Program switch must be plugged into the BLUE port.

1. Door. Open a door.
2. Key. Turn the key to the ON position.
3. Press and release the Valet/Program button within 5 seconds the number of times corresponding to the channel listed below. Once you have selected the channel, press and hold the valet button this time. The LED should flash the same number of times as the channel selected and the siren (if was installed properly) will chirp to confirm the selected channel. DO NOT release the valet button yet.
4. Press the button on the remote that you're assigning to that channel. If the horn siren was works, you should get a chirp and this indicates that the remote has been programmed.
5. Release the Valet button/switch then remove the key from the ignition as this will turn the programming mode off.

This chart works on 473V, 473P, and 473T Remote

This chart works on 473L Remote

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below