Tuesday, February 26, 2019

Rattler 110D Remote Programming Instructions

This Rattler 110D system uses replacement remote: 473T, 7133L, 473V, 473L, EZSDEI474
473T  Remote
473V Remote
473L Remote
7133L Remote
NOTE: Before you use this programming instructions make sure that your system's Valet/Program switch is plugged into it's BLUE port as this will put the system in programming mode to accept new remote.

1. Open the driver door.
2. Insert the key in the ignition and twist it to the ON position.
3. Press and release the Valet/Program button within 5 seconds the number of times corresponding to the channel listed below. Once you have selected the channel, press and hold the valet button this time. The LED should flash the same number of times as the channel selected and the siren (if was installed properly) will chirp to confirm the selected channel. DO NOT release the valet button yet.
4. Press the button from the remote you're assigning to that channel. If the horn siren was works, then you should get a chirp which means the remote has been programmed.
5. Release the Valet/Program button and remove the key from the ignition.

This chart works on 473V, 473P, and 473T Remote

This chart works on 473L Remote

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below