Tuesday, February 26, 2019

Rattler 210D Remote Programming Instructions

This Rattler 210D system uses replacement remote: 473T, 7133L, 473V, 473L, EZSDEI474
473T  Remote
473V Remote
473L Remote
7133L Remote
Please Note: The following Programming Instructions can be used to
program this replacement transmitter to the system in order to enter
the Programming Instructions, The system's Valet/Program switch
must be plugged into the BLUE port.

1. Open your car's door.
2. Put the key in the ignition and turn it to the ON position.
3. Press the Valet/Program button once the number of times corresponding to the channel listed below within 5 seconds. After that, press and hold the valet button this time. The LED should flash the same number of times as the channel selected and the siren (if was installed properly) will chirp to confirm the selected channel. DO NOT release the valet button yet.
4. Transmit. While holding the Valet/Program button, press the button from the transmitter you wish to assign to that channel. The unit will chirp (if horn siren connected) to confirm that the transmitter has been taught to the receiver.
5. Release. Once the code is learned you can release the Valet/Program button and remove the key.

This chart works on 473V, 473P, and 473T Remote

This chart works on 473L Remote

If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below