Wednesday, February 27, 2019

Viper 210 HV Remote Programming Instructions

This Viper 210 HV system uses replacement remote: 473T, 7133L, 473V, 473L, EZSDEI474
473T  Remote
473V Remote
473L Remote
7133L Remote
NOTE: Before you use this programming instructions make sure that your system's Valet/Program switch is plugged into it's BLUE port as this will put the system in programming mode to accept new remote.

1. Open your car's door.
2. Put the key in the ignition and turn it to the ON position.
3. Choose. Within 5 seconds press and release the Valet/Program button the number of times corresponding to the desired channel listed below. Once you have selected the channel, press the Valet/Program button once more and hold it. The LED will flash the same number of times as the channel selected and the siren (if connected) will chirp to confirm the selected channel. Do NOT release button.
4. Press the button on the remote that you're assigning to that channel. If the horn siren was works, you should get a chirp and this indicates that the remote has been programmed.
5. Release the Valet button/switch then remove the key from the ignition as this will turn the programming mode off.
This chart works on 473V, 473P, and 473T Remote

This chart works on 473L Remote

If you can't find your valet switch click here.

No comments:

Post a Comment

Comment below