Saturday, March 2, 2019

Astrostart AF-RF K5225 2-Way Remote Programming Instructions

This Astrostart AF-RF K5225 system uses replacement remote: EZSDEI7701

EZSDEI7701 Replacement Remote
EZSDEI7701 Remote

Please Note: The system can only store up to 4 remotes in it's memory. Your old remotes will be deleted from the system's memory right after a new remote has been programmed. In that case, after programming a new remote you will need to reprogram your existing ones to the system.

1. Open the hood. 2. Put the key in the ignition and turn it to RUN position.
3. Apply the brake once.
4. You now have 10 seconds to turn the key from RUN to STOP position 3 times.
5. If this sequence is correctly carried out, the control module flashes parking lights.
6. Press any button on the new remote control (except the panic button).


Note: Parking lights will flash one time once the new remote has been programmed.

7. To program your exisitng/old remotes (up to 4) you will need to start from step 1 to 6.
8. Apply the brake to turn off the programming mode.
9. You may now test all your remotes.


If your vehicle's system was installed without the valet switch you can order one and install it to make it easier to do the programming.

No comments:

Post a Comment

Comment below