Saturday, March 2, 2019

Astrostart RSS-2205A 2-Way Remote Programming Instructions

This Astrostart RSS-2205A system uses replacement remote: EZSDEI7701

EZSDEI7701 Replacement Remote
EZSDEI7701 Remote

NOTE: This system only accepts up to 4 remotes in it's memory. Your old remotes will be deleted from the system's memory once a new remote has been programmed. In that case, after programming a new remote you will need to reprogram your existing ones to the system.

1. Open the hood.
2. Put the key in the ignition and turn it to RUN position.
3. Apply the brake once.
4. Turn the key in the ignition from RUN to STOP position 3 times within 10 seconds.
5. If you have done the steps right, the system will flash the parking lights.
6. Press any button on the new remote (except the panic button).

(Parking lights will flash one time indicating that the new remote has been programmed.)

7. To program your exisitng/old remotes (up to 4) you will need to start from step 1 to 6.
8. Apply the brake to turn off the programming mode.
9. You may now test all your remotes.

If you can't find a valet switch click here.

No comments:

Post a Comment

Comment below